Husqvarna DM1 PACE Operator's Manual page 9

• High noise levels and long-term exposure to noise
can cause noise-induced hearing loss.
• To keep the noise level to a minimum, do
maintenance on and operate the product as given
in the operator's manual.
• Use approved hearing protection while you operate
the product.
• Listen for warning signals and voices when you use
hearing protection. Remove the hearing protection
when the product is stopped, unless hearing
protection is necessary for the noise level in the work
area.
Personal protective equipment
WARNING:
instructions that follow before you use the
product.
• Always use correct personal protective equipment
when you operate the product. The personal
protective equipment does not erase the risk of
injury. The personal protective equipment decreases
the grade of injury if an accident occurs. Let your
dealer help you select the right equipment.
• Use approved eye protection while you operate the
product.
• Do not use loose, heavy and not applicable clothing.
Use clothes that let you move freely.
• Use approved protective gloves that enables a solid
hold.
• Use rubber protective gloves that prevents skin
irritation from wet concrete.
• Use an approved protective helmet.
• Always use approved hearing protection while you
operate the product. Noise for a long period can
cause noise-induced hearing loss.
• The product makes dust and fumes that contain
dangerous chemicals. Use an approved breathing
protection.
• Use boots with steel toe-caps and non-slip soles.
• Make sure that you have a first aid kit near.
• Sparks can occur when you operate the product.
Make sure that you have a fire extinguisher near.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Never use a product that has faulty safety
equipment! If your product fails any checks contact
your service agent to get it repaired.
• Do not use the product if protective plates, protective
covers, safety switches or other protective devices
are not attached or are damaged.
1941 - 005 - 25.09.2023
Read the warning
Read the warning
Motor overload protection
The motor overload protection engages if the motor has
too high load or the drill bit cannot move freely.
The motor overload protection causes the power from
the motor to decrease and increase in short intervals for
some seconds. Then, if you do not decrease the force,
the motor stops. Refer to
protection on page 17 .
Load indicator
CAUTION:
again can cause damage to the product.
The product has LEDs that show the load of the motor.
Load indicators on page 21 .
Refer to
Functions of the control panel
This operator's manual gives descriptions of the
functions of the control panel for the product. The control
panel operates important functions and setups of the
Troubleshooting of the control panel on
product. Refer to
page 20 to find solutions for the warnings.
2
1
11
10
9
1. On/Off button
®
2. Bluetooth . Refer to
Husqvarna Fleet Services on page 12 .
3. Temperature warning indicator
4. Battery status indicator
5. Warning indicator
6. Load indicator
™
7. Slow Start button
8. Re-bar button. Refer to
16 .
To reset the motor overload
Product overload again and
3 4
8
To connect to the product with
To drill through iron on page
5
6
7
9