Table of Contents
Advertisement
Control and maintenance
Pos: 64 / Beko Techni s che D ok um ent at i o n/ Si c h er hei t / H i n w ei s Vor schr i f t en Wer kzeug R ei n i g ung Kon densat Ent sor gung @ 0\ m od_12332396 66823_ 15098. docx @ 15301 @ @ 1
Note
It is imperative to observe all hazard statements and warnings listed here.
Please also observe all regulations and notes regarding industrial safety and fire prevention at the place of
installation.
As a matter of principle, only use suitable and appropriate tools and materials in a proper condition.
Do not use aggressive cleaners and improper devices such as high-pressure cleaners.
Please note that condensates may contain aggressive or harmful components. Therefore, skin contact
should be avoided.
Condensate is subject to mandatory waste disposal. As such, it must be collected in suitable containers, and
disposed of or processed properly.
Pos: 65 / Beko Techni s che D ok um ent at i o n/ War t ung/ BEKO M AT/ War t ung BM 31U / War t ung BM 31U / 32U ( ni c ht I F) st and- a l o ne 2x8760h @ 5\ m od_13585 096728 52_1509 8. docx @ 30371 @ @ 1
20
Maintenance recommendation:
After 2 x 8,760 operating hours or one million switch-
ing cycles, a maintenance message is released.
The green power LED flashes. Afterwards, or at the
latest after two years (2 x 8,760 operating hours), the
service unit (5) needs to be replaced.
1. Prior to the replacement of the service unit, a reset
needs to be carried out. The control unit is re-
leased by actuating the arresting hook. When re-
moved, the TEST button below the LED must be
pressed and held for at least five seconds.
2. Remove the control unit (1) by pressing the arrest-
ing hook (2).
3. Unfasten the BEKOMAT
4. Remove the design shell (4) (if there is one) using
a screwdriver (10).
5. Detach the service unit (5) from the tubing at the
inlet by removing the union nut.
6. or remove the screws (6) from the angle nozzle
(7).
®
32U from the outlet (3).
BEKOMAT® 32U F
Advertisement
Table of Contents
