Table of Contents
Advertisement
Installation
Pos: 46 / Beko Techni s che D ok um ent at i o n/ Si c h er hei t / H i n w ei s Vor schr i f t en Wer kzeug R ei n i g ung Kon densat Ent sor gung @ 0\ m od_12332396 66823_ 15098. docx @ 15301 @ @ 1
Note
It is imperative to observe all hazard statements and warnings listed here.
Please also observe all regulations and notes regarding industrial safety and fire prevention at the place of
installation.
As a matter of principle, only use suitable and appropriate tools and materials in a proper condition.
Do not use aggressive cleaners and improper devices such as high-pressure cleaners.
Please note that condensates may contain aggressive or harmful components. Therefore, skin contact
should be avoided.
Condensate is subject to mandatory waste disposal. As such, it must be collected in suitable containers, and
disposed of or processed properly.
Pos: 47 / Beko Techni s che D ok um ent at i o n/ I nst al l a t i o n/ B EKO M AT/ BM 31/ 32/ 33+U + AU ( ni c ht Var i o ) I nst al l a t i onshi nw e i s e @ 0\ m od_11841616 40511_1 5098. docx @ 15126 @ @ 1
Installation instructions:
14
•
Only the displayed installation position of the
BEKOMAT (3) is permissible. Never install in a hor-
izontal or any other tilted position.
•
Feed pipe (1) and ball valve (2) at least G½.
•
No filter or screen in the inlet line.
•
Slope in the inlet line >1%.
•
Use ball valves (2) only.
•
Operating pressure: min. 0,8/1,2 bar (12/17 psig),
max. 16 bar (230 psig). See type plate.
•
Short pressure hose (4) fixed on a pressure-re-
sistant pipe.
•
The required minimum pressure increases by
0,1 bar (1,4 psi) per metre gradient in the dis-
charge pipe (5).
•
Discharge pipe (5) rising by max. 5 m (16,4ft).
•
Install manifold (6) ½" with a slope of 1%.
•
Introduce the discharge pipe (5) from the top into
the manifold (6).
•
Prior to the start-up, always carry out a leak test
and verify the correct engagement of the control
unit.
BEKOMAT® 32U F
Advertisement
Table of Contents
