Programming Vrx1 Manually; Access Menu Settings Without A Zaxcom Gui Bridge (Zgb) - Zaxcom VRX1 User Manual

Zaxcom VRX1

Programming VRX1 Manually

Access menu settings without a Zaxcom GUI Bridge (ZGB)

1. Power on the device. Within a few seconds of powering on, depress both the A/B and * buttons
simultaneously. A LED will turn white and you will hear a voice prompt for channel selection.
2. Short press the A/B key to cycle forward through available channels. You will hear an audio prompt
through the headphone announcing the choices. Long press the A/B key to go to the previous channel.
3. Once a channel has been selected, short press the * key to advance menu parameters for that channel.
•
4. Once you are satisfied with your selections, wait three seconds, power the device off and then on.
If a VRX1 is left in this menu, it will default to normal operating mode after 30 seconds of inactivity.
MENU STRUCTURE:
Channel Selection
Short press A/B to cycle
Long press A/B to go back
Short press * to ADVANCE
1
2
3
4
5
6
7
8
9
10
Press A/B to select. Press the * key to go back to the previous list of settings.
CHANNEL
ENABLE
DELAY
VOTING
Parameters
Short press A/B to Select
Short press * to Cycle
Page 11
VHF Receiver
Enable Options
Short press A/B to toggle
Short press * to ESC
Channel ON
Channel OFF
Delay Options
Short press A/B to toggle
Short press * to ESC
ON
OFF
Voting Options
Short press A/B to toggle
Short press * to ESC
ON
OFF