Zaxcom VRX1 User Manual page 10

Zaxcom VRX1
ANNOUNCE: * key will prompt the VRX1 to announce the current channel selection.
•
• Holding down the * key on bootup will announce the receiver's firmware and current selected channel
settings.
16. RF Mode: Toggles between FM analog and digital modes. FM is the only mode available.
17. Compander: Toggles adjustment of the compander settings for the receiver unit. Currently, Compander 1 is
the default and is compatible with Comtek transmitters on companded channels. Turning the compander off
will make VRX1 compatible with uncompanded channels but will result in degraded audio quality.
18. Battery Type: Adjusts the battery metering for NIMH, alkaline, or lithium batteries.
19. Encryption: Sets receiver encryption for digital reception mode. This function is not available in FM analog
mode.
20. Bass Boost: Toggles a low-frequency boost for frequencies below 320Hz on the VRX1 unit. Choices are:
Normal, +3dB, +6dB.
21. Presets: Loads saved preset settings for VRX1.
22. Read VRX: Uploads the current settings while connected to a Zaxcom GUI Bridge.
23. Write VRX: Writes selected settings while connected to a Zaxcom GUI Bridge.
Page 10
VHF Receiver