Kathy Ireland PACIFICO 53533 Use And Care Manual page 9

Assembly - Hanging the Fan (continued)
2
Hanging the fan
□
Carefully lift the fan motor assembly (E) up to the slide-on
mounting bracket (A).
□
Insert the ball portion of the ball/downrod assembly (B)
into the socket of the slide-on mounting bracket (A).
□
Turn the ball/downrod assembly (B) clockwise until it is
seated with the tab of the slide-on mounting bracket (A)
aligned with the slot in the ball.
3
Setting the code on the
remote control and receiver
NOTE: The frequencies on your receiver and hand unit
have been preset at the factory. Before installing the
receiver, make sure the dip switches on the receiver
and hand unit are set to the same frequency. The dip
switches on the hand unit are located inside the battery
compartment.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place as this will damage
the hand unit. Dispose of used battery properly and keep
the battery out of the reach of children.
□ Remove the remote control (L) battery cover by pressing firmly on
the arrow and sliding the cover off.
□ Slide the dip switches (ZZ) to your choice of either up or down. The
factory setting is up.
□ Slide the dip switches (ZZ) on the receiver (K) to the same position
as set on the remote control (L).
□ Install the 23A 12V battery (M).
□ Replace the battery cover on the remote control (L).
□ Insert the silicone rubber stopper (OO) into the hole on the receiver
(K) to cover the dip switches.
9
Please contact 1-888-757-7697 for further assistance.
O
D
ZZ
L
OO
A
C
O
B
D
E