Kathy Ireland PACIFICO 53533 Use And Care Manual page 13

Assembly - Attaching the Light Kit (continued)
2
Attaching the light kit fitter assembly
□
Remove one screw (GG) from the light kit pan (G), and loosen,
but do not remove, the other two screws.
□
Connect the wires from the light kit fitter assembly (H) to
the wires from the fan motor assembly (E) by connecting the
molded adaptor plugs together. Carefully tuck all wires and
splices into the switch cup.
□
Push the light kit fitter assembly (H) up to the light kit pan
(G) so that the two loosened screw heads fit into the keyhole
slots. Turn the light kit fitter assembly (H) clockwise to secure.
□
Re-install the screw that was removed in the first step.
□
Make sure all the screws are firmly tightened.
3
Installing the PP shade
WARNING: Do not overtighten when installing the PP shade
into the light kit. Allow the PP shade to cool completely before
removing.
□
Place the PP shade (I) into the light kit pan (G), aligning the
three flat areas on the top of the flange of the PP shade (I)
with the three raised dimples in the light kit pan (G). Turn the
PP shade clockwise until it stops.
Assembly - Attaching without a Light Kit
1
Attaching the cap for non-light kit use
NOTE: : Do not install LED light fixture if using the non-light kit
cover (J).
□
Place the non-light kit cover (J) into the light kit pan (G),
aligning the three flat areas on the top of the flange of the
non-light kit cover (J) with the three raised dimples in the light
kit pan (G).
□
Turn the non-light kit cover (J) until it stops.
GG
I
J
13
Please contact 1-888-757-7697 for further assistance.
G
H
G
G