Kathy Ireland PACIFICO 53533 Use And Care Manual page 11

Assembly - Hanging the Fan (continued)
6
Wiring the fan to the receiver
NOTE: The fan comes with 12 in. lead wires for use with
the provided 8 in. ball/downrod assembly (B). If you wish
to use a longer downrod, use the extension lead wire (N)
provided.
□
If using the 8 in. ball/downrod assembly (B) provided, wire the
receiver to the fan wires by connecting the molded adaptor
plug from the receiver (J) with the molded adaptor of the fan
motor assembly (E) together.
□
If you wish to use longer downrod, you can use the extension
lead wire (M) provided by connecting the molded adaptor
together.
7
Mounting the fan motor assembly
(standard mount)
WARNING: When using the standard ball/downrod
mounting, the tab in the ring at the bottom of the
mounting bracket must rest in the groove of the
hanger ball. Failure to properly seat the tab in the
groove could cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Align the locking slots of the canopy (C) with the two screws
(SS) and alignment post in the slide-on mounting bracket (A).
□
Push up the canopy (C) and turn it clockwise until the
alignment post engages to the round hole and the screws (SS)
engage to the key slots.
□
Firmly tighten the two mounting screws (SS).
□
Align the oval shape on the canopy (C) with canopy bottom
cover (O).
□
Push up the canopy bottom cover (O) until the screw (SS)
heads engage to the slots on the canopy bottom cover (O) so
that the magnetic canopy bottom cover (O) can be attached to
the bottom of the canopy (C) properly.
M
11
Please contact 1-888-757-7697 for further assistance.
Outlet box
in the ceiling
Green
ON DIP
1 2 3 4
(II)
A
SS
C
O
B
E