Kathy Ireland PACIFICO 53533 Use And Care Manual page 10

Assembly - Hanging the Fan (continued)
4
Installing the receiver
WARNING: To reduce the risk of fire or electric shock,
remember to disconnect the power. The electrical
wiring must meet all local and national electrical
code requirements. The electrical source and fan
must be 110/120 volt, 60Hz. Do not use this product
in conjunction with any variable wall control. Incorrect
wire connection can damage this receiver.
CAUTION: If other fan wires are a different color, have this
unit installed by a licensed electrician.
CAUTION: Do not install the receiver in a damp location
or immerse in water (for indoor use only). Do not pull on
or cut the receiver leads shorter. Do not drop or bump
the unit.
□
Position the house supply wires (AAA) to one side of the
slide-on mounting bracket (A); position the fan wires (BBB)
to the opposite side.
□
Insert the narrow end of the receiver (K) (as shown, fat side
towards the ceiling) into the slide-on mounting bracket until
it rests on top of the ball/downrod assembly.
5
Wiring the receiver to the
household wiring
WARNING: To avoid possible electrical shock, turn
the electricity off at the main fuse box before
wiring. If you feel you do not have enough electrical
wiring knowledge or experience, contact a licensed
electrician.
WARNING: Each wire nut supplied with this fan is
designed to accept up to one 12-gauge house wire
and two wires from the fan. If you have larger than
12-gauge house wiring or more than one house wire to
connect to the fan wiring, consult an electrician for the
proper size wire nuts to use.
IMPORTANT: Use the wire connecting nuts (BB)
supplied with your fan. Secure the connectors with
electrical tape and ensure there are no loose strands or
connections.
□
Spread the wires apart so that the green and white wires
are on one side of the outlet box and the black wire is on the
other side.
□
Connect the green fan wires to the household ground wire
(this may be a green or bare wire) using a wire connecting
nut (BB).
□
Connect the receiver (J) black (or red) wire to the household
black (hot) wire using a wire connecting nut (BB).
□
Connect the receiver (J) white wire to the household white
wire (neutral) using a wire connecting nut (BB).
□
Secure each wire connecting nut using electrical tape.
AAA
BB (x3)
Black
Black
(or Red)
Receiver
Antenna
K
10
K
BBB
B
K
Receiver (K) correctly
positioned in the
mounting bracket.
Outlet Box
Green (or Bare)
White
Green
ON DIP
1 2 3 4