Download Print this page

SIGNIFY CHLORIDE CCSE Series Installation page 2

Advertisement

INSTALLATION INSTRUCTIONS FOR CSE[X]RWW EXIT SIGN
These instructions do not purport to cover all details or variations in equipment nor to provide every possible
contingency to meet in connection with installation, operation, or maintenance. Should further information be
desired, or should particular problems arise which are not covered sufficiently for the purchaser's or owner's
purposes, this matter should be referred to the Customer Care Call Center at 800‐555‐0050.
Please see luminaire‐specific Installation and Maintenance Instruction for additional warnings or any applicable
FCC or regulatory statements. Failure to follow any of these instructions could void luminaire warranties.
Luminaire Maintenance and Operation
Regular luminaire maintenance programs are recommended.
It is recommended to clean the outside of the luminaire and the refractor/lens.
Frequency of cleaning will depend on ambient dirt level and minimum light output which is acceptable to the
user.
If clean water is not sufficient for cleaning, use a neutral, synthetic, non‐scratching, and non‐abrasive cleaning
substance.
Never use alkaline and/or acetous cleaning substances.
Make sure that the cleaning substance is carefully removed by rinsing with lots of clean water.
Signify recommends using a cleaning solution that has a PH between 5 and 8.
Recycle: For information on how to recycle electronic products and components, please visit
To test self powered units, depress test switch, lamp head will remain lit when switched to battery power.
Release test switch, lamp head will operate with AC supply.
Servicing of any parts should be performed by qualified personnel. For replacement parts to see fixture label
for proper identification of manufactory.
Replace batteries according to ambient conditions. Equipment should be tested regularly in accordance with
local codes.
Max mounting height: 35 ft.
CAUTION:
This equipment used special circuit diagram to protection for LiFePO
and over discharge. Allow 24 hour recharge time after installation or power failure for full load testing.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
page 2 of 4
www.epa.gov.
battery overcharge
4

Advertisement

loading
Need help?

Need help?

Do you have a question about the CHLORIDE CCSE Series and is the answer not in the manual?

Subscribe to Our Youtube Channel