SIGNIFY CHLORIDE CWCRW1 Installation

INSTALLATION
WARNINGS AND INSTRUCTIONS FOR LUMINAIRES
IMPORTANT: FOR YOUR PROTECTION, YOU MUST CAREFULLY READ ALL WARNINGS AND INSTRUCTIONS IN THEIR ENTIRETY
PRIOR TO INSTALLATION, OPERATION, SERVICE, OR MAINTENANCE. FAILURE TO DO SO CAN RESULT IN DEATH, PERSONAL
INJURY AND PROPERTY DAMAGE. If you do not understand these warnings and instructions, or if additional information is
desired, please contact the Customer Care Call Center at 800‐555‐0050.

Installation, service, and maintenance of luminaires must be performed by a qualified professional and in accordance
with all federal, state, and local laws, regulations, and electrical codes. This professional should be familiar with the
construction and operation of this product and any hazards involved. If not qualified, do not attempt installation,
service or maintenance.

To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts,
abrasions, and other hazards, please read all warnings and instructions included with the luminaire, on the
luminaire's packaging and affixed to the luminaire itself.

Maintenance of the luminaires should be performed by person(s) familiar with the luminaire's construction
and operation and any hazards involved.
WARNING
RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL INJURY

Disconnect or turn off power before attempting any installation, service or
maintenance.

Verify that supply voltage is correct by referencing the luminaire label
information.

Make all electrical and ground connections in accordance with the
National Electrical Code (NEC) and any other applicable laws, regulations,
or codes.

All wiring connections should be capped with UL‐approved wire
connectors.
WARNING
RISK OF PERSONAL INJURY

Keep combustible materials away from LED/lamp & lens.

Do not operate in close proximity to persons, combustible materials or
substances affected by heat or drying.
CAUTION
RISK OF PRODUCT DAMAGE
Never connect luminaires and/or components under load with supply voltage turned on.

Do not mount or support these luminaires in a manner that can cut the outer jacket or damage wire insulation.

Do not restrict fixture ventilation. Allow for some volume of airspace around the luminaire. Avoid covering the luminaire

with insulation, foam, or other material that will prevent convection or conduction cooling.
Do not exceed luminaire maximum ambient temperature.

Do not modify the luminaire.

Only use luminaire in its intended application and location.

LED products are polarity sensitive. Ensure proper polarity before installation.

Electrostatic Discharge (ESD) can damage LED. Personal grounding equipment must be worn during all installation

and servicing of the luminaire.
Do not touch individual electrical components as this can cause ESD, shorten LED life, or impact LED performance.

Some components inside the luminaire may not be serviceable. In the unlikely event, your luminaire may require service,
stop using it immediately and contact the Customer Care Call Center at 800‐555‐0050.
Always read the luminaire's complete installation instructions prior to installation for any additional luminaire‐ specific

warnings.
In the case of HID or Fluorescent luminaires, regular re‐lamping is required to keep the luminaire operating within safe

limits.
WARNING
RISK OF PERSONAL INJURY

Wear gloves and safety glasses at all times when removing luminaire
from carton, installing, servicing or performing maintenance.

Avoid direct eye exposure to the light source while it is on.
WARNING
RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL INJURY

Allow LED/lamp & lens to cool before handling.

Do not touch enclosure or light source.

Do not exceed maximum wattage marked on luminaire label.

Follow all manufacturer's warnings, recommendations, instructions, and
restrictions for driver type, burning position, mounting locations and
replacement.
Page 1 of 5