Panasonic TOUGHBOOK CF-M34 Series Operating Instructions Manual page 23

Display
After the display destination
of the screen is switched
with ( Fn ) + ( F3 1 the dis¬
play destination returns to
both the internal LCD and
external display upon op¬
eration
Under the condition that the [MS-DOS Prompt]* screen is set to "Full Screen", the display
destination returns to both the internal LCD and external display if "EXIT" is input and the
[MS-DOS Prompt]* screen is closed, or "Full Screen" is canceled (e.g.,
CAItJ+( Enter)),
when the display destination of the screen is switched with
C FrO + ( F3 ).
Press (
Fn ) +
C
F3
) again.
4W indows}2000U4Wi ndowslNTft
[Command Prompt]
Shutting down
Unable to shut down Win¬
dows
If a USB device is connected, try removing it.
Battery Indicator
The red indicator lights.
Repeated beeping sound
while the computer is in use.
The battery level is low. Save your data and power off your computer.
After connecting the AC adapter or replacing the battery pack with a fully charged one, turn
your computer on.
The red indicator blinks
• The battery pack or recharging function may be defective. Quickly remove the battery
pack and disconnect the AC adapter, then connect them again.
• If the problem persists, contact Panasonic Technical Support.
The orange indicator blinks
Unable to charge because of an improper temperature range. (Q3 page 6)
Application Software
Press
COtrD + CSD + CSeD
and select [Shut Down].
After cutting the power by sliding the power switch for more than four seconds, slide the
power switch to power on and open the application again.
If the program no longer works normally, go to [Start] - [Settings] - [Control Panel] -
[Add/Remove Programs] to delete the program. Then reinstall the program.
Reference Manual
The Reference Manual is
Is Acrobat Reader installed?
not displayed
If Acrobat Reader is not installed, run [c:\util\reader\ar500enu.exe]* in [Start] - [Run] to
reinstall the program. When installing the program, do not change the installation destina-
tion folder. If the destination folder is changed, the Reference Manual cannot be opened
from the [Start] menu.
*C 3: [c:\util\reader\ar500.exe]
23