Panasonic TOUGHBOOK CF-M34 Series Operating Instructions Manual page 13

10
Label on the top surface,
and insert the shutter-
side headfirst.
USB Floppy
Disk Drive
Create Backup Disks for Reinstallation
Prepare 2HD floppy disks and make sure they are not in the write-protected state, then
select [Start] - [Programs] - [Panasonic] - [Create BACKUP DISK] and follow the on¬
screen instructions. Place a label identifying the contents on each disk.
• Name of created backup disk
FIRSTA1D FD (When the display for creating the UPDATE FD is shown, create the
disk by following the on-screen instructions.)
(?) Power off your computer (£jp [Q~~] "Starting Up/Shutting Down")
Do not shut down using the standby or hibernation mode.
(2) Connect the external floppy disk drive to your computer.
Xnote)-—--
The floppy disk drive must be the A drive.
V_/
(5) Turn on your computer.
(
4
) Set a floppy disk and make sure it is not in the write-protected state.
(
5
) Select [Start] - [Programs] - [Panasonic] - [Create BACKUP DISK].
Follow the on-screen instructions. Place a label identifying the contents on each
disk.
:---x
• Store the floppy disks in a safe place. They will enable you to return your
computer to close to the condition at the time of purchase should any problems
occur.
When creating backup disks, do not run any other application program.
• When creating backup disks and the message [Insufficient files to copy] is dis¬
played, select [OK] and then contact Panasonic Technical Support.
• While the floppy disk drive indicator is on, do not remove the floppy disk,
power down your computer or use the standby or hibernation function (Q3
"Standby/Hibemation Functions").
• Be sure to create the backup disk.
If a backup disk is not created, it will be impossible to return the computer to its
original state. In this case, contact Panasonic Technical Support.
NOTE
When a new device has been installed or a new Windows Component has been added in
[Start] - [Settings] - [Control Panel] - [Add/Remove Programs], [Insert Disk] may appear.
Select [OK] and specify [c:\winnt\cdimage] in place of [c:\sysprep\i386] or [D:], then
select [OK].
e.g. [c:\winnt\cdimage\i386] in place of [D:\i386]
dB msp
• The library able to be used with the retail version of Windows NT 4.0 for Service
Pack6 is in the following folder on the hard disk drive.
c:\winnt\i386\drvlib
• The partition showing [Unknown xxxMB] (in [Start] - [Programs] - [Administrative
Tools (Common)] - [Disk Administrator]) is an important partition. Therefore, do not
delete this partition.
13