Related Manuals for GABOR LEVITOUCH GPW-50
Summary of Contents for GABOR LEVITOUCH GPW-50
- Page 1 GPW-50 / LEVITOUCH SINGLE ARM MONITOR WALL MOUNT for 17 to 32 in. Displays Levi Touc h GPW User Manual...
- Page 2 Thank you for choosing Gabor. The Gabor Levitouch wall-mount monitor arm will support a monitor from 17 to 32 inches that weighs up to 19.8 pounds. This monitor arm is designed to be inconspicuous and take up minimal wall space while it offers optimum viewing angles whether you’re sitting or standing.
-
Page 3: Safety Warnings
• Clean this product with only a soft, dry Monitor Tilt cloth. • Gabor takes no responsibility for any +90°, -45° product damage or personal injury resulting from mishandling, incorrect • All images are for illustrative purposes Monitor Rotation mounting, faulty assembly, or improper only. - Page 4 Overview Required tools: Scissors Drill Level Socket Wrench Pencil Optional: Stud finder PARTS FOR MOUNTING ON A WALL PARTS FOR MOUNTING A MONITOR M4 × 12 M5 × 12...
-
Page 5: Mounting The Monitor
Mounting the Monitor Unpacking Important! We recommend that two people perform these steps. Use Caution Unpacking the Arm Hold the two halves of the arm together while another person cuts the packing cable. Slowly release the pressure on the spring arm and allow it to gradually stretch to its full extension. - Page 6 (W-C) and screws (W-A). Place a level along the side of the mounting plate, and use the plate as a template to mark the location of the holes. LeviTouch GPW-50 LeviTouch GPW-50 Once the Arm is LeviTouch GPW-50 attached, place the caps (B) into the holes.
- Page 7 Tap the wall anchors (W-B) into Place a level along the the holes, and attach the arm to side of the mounting LeviTouch GPW-50 the wall with the washers (W-C) plate, and use the plate and screws (W-A). as a template to mark LeviTouch GPW-50 the location of the holes.
- Page 8 Mounting a Monitor to the Arm Note: Hand-thread one of the M-A or M-B screws to determine which one fits your monitor. Slide washers M-C onto the appropriate screws. Screw two of the mounting screws (M-A or M-B) into your monitor’s top two VESA holes with a Phillips screwdriver.
- Page 9 100 × 100 VESA Pattern 75 × 75 VESA Pattern Use the two installed mounting screws to hang Use the two installed mounting screws (M-A the monitor on the VESA plate’s two top or M-B) and washers (M-C) to hang the VESA notches.
- Page 10 Adjusting the Arm’s Gas-Spring Tension When the arm is adjusted to the ideal tension, it will hold the To adjust the arm’s tension, follow these steps: monitor in position indefinitely. Support the monitor with one hand, and position the arm and monitor so the arm is horizontal.
- Page 11 Adjusting the Monitor Adjusting the Arm Cable Organization Tilt Angle Swivel Tension If the tilt angle of the monitor won’t move, use the hex Adjust the swivel tension by tightening After the monitor is installed, keep your cables wrench (C) to slightly loosen the screws on both sides or loosening the two adjustment neat and organized by running them through of the VESA plate.
- Page 12 To obtain warranty coverage, contact the Gabor Customer Service Department to obtain a return merchandise authorization (“RMA”) number, and return the defective product to Gabor along with the RMA number and proof of purchase. Shipment of the defective product is at the purchaser’s own risk and expense.