Datavideo PTC-285TW Instruction Manual page 59

Step 14. Please click the "Apply" button .
Step 15. Please click the "Reboot" button in the "System" option to reboot the
PTC-285T.
Step 16. After the PTC-285T is rebooted, please use an SDI cable to connect
from the 3G-SDI interface which is located on the rear panel of the PTC-285T
to the SDI IN interface which is located on the rear panel of the HS-1300, or
you can use an HDMI cable to connect from the HDMI interface which is
located on the rear panel of the PTC-285T to the HDMI IN interface which is
located on the rear panel of the HS-1300. After that, you can see the image
which is shot by the PTC-285T is displayed in the MULTIVIEW window of the
HS-1300 correctly.
For SDI: The SDI IN 1 to SDI IN 4 interfaces which are located on the rear panel
of the HS-1300 represent the MULTIVIEW window's Input 1 to Input 4.
For HDMI: The HDMI IN 1 to HDMI IN 2 interfaces which are located on the
rear panel of the HS-1300 represent the MULTIVIEW window's Input 5 to Input
6.
Note: Datavideo's SE-650, HS-1200 MU and HS-1300 switchers support 1080i
video format only. So, the 1080p video format is not supported by the above-
mentioned switchers. If you want to connect the PTC-285T camera to the SE-
650 or the HS-1200 MU switcher, please remember to select the "Dial Priority"
item from "Video Video Format" in the PTC-285T web UI. Moreover, please
use the OSD menu of the PTC-285T camera and the OSD menu of the above-
mentioned switchers to adjust them in the same video standard before
59