Table of Contents
Advertisement
C. Termination Requirements
‡
,QVWDOO D FDS DSSURYHG DQG OLVWHG IRU WKLV ¿UHSODFH V\VWHP
‡
/RFDWH FDS ZKHUH LW ZLOO QRW EHFRPH SOXJJHG E\ VQRZ RU RWKHU PDWHULDOV
•
Locate cap away from trees or other structures.
‡
7KH ERWWRP RI WKH WHUPLQDWLRQ FDS PXVW EH DW OHDVW IW P DERYH WKH URRI $1' DW OHDVW IW P DERYH DQ\ SRUWLRQ
RI URRI ZLWKLQ IW P DV VKRZQ LQ )LJXUH
‡
7KH GLVWDQFH UHTXLUHG EHWZHHQ FDSV LV VKRZQ LQ )LJXUH
Slanted Roofs
Chimney must
extend 3 ft (.9 m)
above the roof
Flat Roofs
Chimney must
extend 3 ft (.9 m)
above the roof
Multiple Chimney Locations
A
6 in. (minimum) up to 20 in.
152 mm/508 mm
20 in. and over
Figure 5.3
Multiple Chimney Locations
Heatilator • C40-C Constitution Installation Manual • 4186-901 • Rev H • 03/23
Chimney must extend 2 ft (.6 m)
above any portion of the roof or
adjacent structures within
10 ft (3 m) of the chimney
B
18 in. minimum
457 mm
0 in. minimum
Gas
Termination
Cap **
*
If using decorative cap cover(s), this distance may need to be
increased. Refer to the installation instructions supplied with the
decorative cap cover.
**
In a staggered installation with both gas and wood terminations, the
wood termination cap must be higher than the gas termination cap.
Chimney must extend 2 ft (.6 m)
above any portion of the roof or
adjacent structures within
10 ft (3 m) of the chimney
Gas, Wood or Fuel Oil
Termination Cap
B
A *
Wood
Minimum
(See
illustration
above)
Advertisement
Table of Contents
