Table of Contents
Advertisement
• adjust the height and levelling with the adjustment feet, also
checking correct door closing.
•
F.6
Plumbing connection (only if present)
CAUTION
The plumbing connection must be carried
out by a specialised personnel.
The appliance has a drain hole for any liquids present in the
compartment. Connect the compartment drain hole "D", located
on the bottom of the appliance and provided with a closing plug,
to a drain. The drain hole diameter is "17.5 mm", therefore it is
advisable to connect it to a "17.5 mm" drain pipe.
D
F.7
Reversing opening of fully insulated
doors
CAUTION
The user cannot reverse the door opening
direction in all models with glass door.
Models with glass door come with opening
from left to right. To reverse the opening
direction in refrigerated models, call the
Customer Care Service.
Single- door refrigerated cupboards are normally supplied with
right opening. When converting to left opening, proceed as
follows:
• open the control panel, loosening the 2 screws located
between the panel and door;
• undo the 2 fixing screws of bracket "A" and the screw securing
hinge "B" (detail 1);
• remove the door and remove hinge "B" from right to left, break
the precut "F" on the opposite side and insert part "B" (detail 6)
and the bracket as shown in the figure;
• remove the lower bracket "D", refitting it in the special seat on
the opposite side (detail 2);
• position the door on the lower bracket "D";
• position the upper bracket "A" between the door and the roof
of the appliance, tightening the fixing bolts;
• before tightening the screws, align the door with the panel of
the cabinet, adjusting the lower and upper brackets and
making sure the seal is perfectly fitted on all sides;
• then tighten the bracket fixing bolts;
• fix the control panel again, securing the 2 screws between the
control panel and door.
NOTE!
After doing the above operations, the holes in the
appliance must be closed with the special plastic
plugs.
19
Advertisement
Table of Contents
