Switch On The Power - Technics SA-GX505 Operating Instructions Manual

Note:
a4
Memory indicator
The indication AM used here
includes both MW and LW.
Tape indicator
A
¢
J
1 Switch ON the power.
tuminated.
If the tape indicator is illuminated, press this switch.
Turn the tuning control so as to tune to the
desired broadcast.
1
"Az —
Press the memory button momentarily.
(The memory indicator will illuminate.)
Note:
If the memory button is pressed and held until the
frequency begins to change, the automatic memory
presetting (Refer to page 16.) is activated. To stop the
automatic memory presetting, once again press the
memory button. Then begin again from step 7.
To cancel the memory function, press the memory button
again.
Select the desired "CHANNEL".
To designate channels 1—9:
Press the appropriate (1—9) preset-tuning button.
To designate channels 10-30:
@ Press the button for the most significant digit (1, 2 or 3).
@ Press the button for the least significant digit (1—0)
within 2 seconds after pressing the first button.
Note:
If the interval between pressing the first button and press-
ing the second button is more than about 2 seconds, the set-
ting may not be made correctly. If this happens, make the
setting once again (following step 8).
Repeat steps 5 through 9 to make additional
memory presettings; for later reference,
note the presettings in the station memory
file on page 18.