Listening To Radio Broadcasts - Technics SA-GX505 Operating Instructions Manual

Listening to Radio Broadcasts
Manual tuner operation
1 Switch ON the power.
Select the "'A" and/or "B" speaker system(s)
to be used.
Check to be sure the tape indicator is not
illuminated.
If the tape indicator is illuminated, press this switch.
A Press the "TUNER" button.
Press the "FM", "LW" or "MW" button.
Before tuning to the broadcast stations, press to select the
appropriate frequency step for your locality. (Refer to page
9.)
Select the desired tuning mode, "AUTO" or
"MANUAL".
S15.
Turn the tuning control so as to tune to the
desired broadcast.
In "AUTO" mode, the next station, higher or lower in broad-
cast frequency, will be automatically tuned in.
In "MANUAL" mode, the frequency will change, using the
smallest step available, only as the tuning control is being
turned. This will allow you to tune in all of the broadcast fre-
quencies available in that band.
If you want to lock the broadcast channel presently being
heard, press the tuning-mode selector to select the
"LOCK" position.
Adjust the volume level and the tone
quality as desired.
(Refer to page 14.)
lf noise is excessive in the FM mode
Press the FM mode selector.
The sound will then be heard in monaural and the FM stereo in-
dicator will not illuminate. If the broadcast signal is weak, or if
there is a large amount of interference, sounds can be heard
more clearly.