Table of Contents
Advertisement
Available languages
Available languages
1 2
Headphones
(not included)
Plug type:
6.3 mm phone
plug stereo type
1 Switch ON the power.
Select the "A" and/or "B" speaker system(s)
to be used.
Select the audio or video source.
TAPE/DAT MONITOR: Press this button to listen to tape or
No other sources
selected by the input selector can be
heard while the tape indicator is illuminated. To listen to
PHONO: Press this button to listen to phono discs.
Note:
;
player should be switched OFF when it is not being used.
A Start the audio or video source.
(Refer to the appropriate operating instructions for details).
5 Adjust the volume level.
While listening to music
[LOUDNEsS|
Set to "ON"
position when
listening at low
volume level.
(The loudness indicator will illuminate.)
Tape indicator
Loudness indicator
=445
LOUDNESS || BALANCE
To listen to a desired audio source
while watching video picture
| Follow steps 1~2 at the left.
Select the desired video source and audio
source in step 3 at the left.
Be sure to select the video source first.
Start the video and audio source.
When listening through headphones
Use the volume control to reduce. the volume level, and con-
nect the headphones to the headphones jack.
® If sound from the speakers is not wanted, set the speaker selec-
tors ("SPEAKERS") to the "OFF" position.
¢ Set the Dolby 3 stereo ON/OFF button and Dolby Pro-Logic Sur-
round ON/OFF button to OFF when the center speaker and/or
rear speakers are connected.
¢ Avoid listening for prolonged periods of time to prevent hearing
damage.
After use
Be sure to reduce the volume
level, and switch the power to
standby
mode
from
the remote-control
transmitter
or by the
power " d STANDBY/ON"
switch of this unit.
Note:
The input selection and the muting settings will be retained (as
they were at the time when the power was switched to standby
mode) by the memory back-up function.
Advertisement
Table of Contents
