Lh42C4Nt1P Dc Input/Transistor Output Combined Module (Sink Type) - Mitsubishi Electric MELSEC-L Series User Manual

4.4.1
LH42C4NT1P DC input/transistor output combined module
(Sink type)
Item
 Input specifications
Number of input points
Rated input voltage
Rated input current
Input ON voltage/ON current
Input OFF voltage/OFF current
Input resistance
OFF to ON
Input response
time
ON to OFF
Input common terminal arrangement
 Output specifications
Number of output points
Rated load voltage
Maximum load current
Maximum inrush current
Leakage current at OFF
Maximum voltage drop at ON
OFF to ON
Output
response time
ON to OFF
Surge suppressor
Fuse
Voltage
External power
supply
Current
Output common terminal
arrangement
Overload
protection function
Protection
function
Overheat
protection function
 Common specifications
Withstand voltage
Isolation resistance
Noise immunity
Protection degree
Number of occupied I/O points
External interface
5VDC internal current consumption
Weight
Specifications
32 points
24VDC (ripple rate: 5% or less) (Allowable voltage range: 20.4 to 28.8VDC)
4.0mA TYP. (at 24VDC)
19VDC or higher/3mA or higher
9VDC or lower/1.7mA or lower
5.7k
1ms, 5ms, 10ms, 20ms, 70ms or less
(PLC parameter setting of CPU module) Initial setting is 10ms.
1ms, 5ms, 10ms, 20ms, 70ms or less
(PLC parameter setting of CPU module) Initial setting is 10ms.
32 points/common (common terminal: 1B01, 1B02)
32 points
10.2 to 28.8VDC
0.1A/point, 2A/common
Current is limited by the overload protection function.
0.1mA or less
0.1VDC (TYP.) 0.1A, 0.2VDC (MAX.) 0.1A
0.5ms or less
1ms or less (rated load, resistance load)
Zener diode
None
12/24VDC (ripple rate: 5% or less) (Allowable voltage range: 10.2 to
28.8VDC)
9mA (at 24VDC)/common
32 points/common (common terminal: 2A01, 2A02)
Limited current when detecting overcurrent: 1 to 3A/point
Activated to each point. (Page 54, Section 4.4)
Activated to each point. (Page 54, Section 4.4)
510VAC, 1 minute (altitude 2000m)
10M or more by insulation resistance tester
By noise simulator of 500Vp-p noise voltage, 1µs noise width and 25 to 60Hz
noise frequency
IP2X
32 points (I/O assignment: input/output 32 points)
40-pin connector (Page 65, Section 6.2.2)
160mA (TYP. all points ON)
0.12kg
CHAPTER 4 SPECIFICATIONS
Appearance
55
4