Maintenance; General Safety Measures - Herz firestar 15 Operating Instructions Manual

MAINTENANCE

General safety measures

Safety rules according to Ö–NORM are:
Switch off all poles on all sides
Ensure that they is not switched on again
Check that there is no voltage
Earth and short-circuit
Covering neighbouring live parts
and isolate dangerous parts
In order to prevent any commissioning errors due to incorrect maintenance, it is
recommended that regular maintenance servicing be carried out by authorised staff or
the HERZ factory customer service.
Spare parts may only be obtained direct from the manufacturer or sales partner. No
health risks will be caused to the customer from noise arising from the machinery.
Details of any residual risks can be requested from the residual risk analysis from Herz
as required.
Betriebsanleitung firestar 15-40 English V2.8
Before commencing any work on the equipment, but particularly
before opening coverings of parts under voltage, the equipment
must be enabled according to the instructions. As well as the
main electrical circuit, any additional or auxiliary circuits should
be noted. The usual
The aforementioned measures may only be retracted once the
equipment is completely installed and the maintenance
completed.
For overhaul work in the combustion chamber, ash chamber, on
flue gas-carrying parts, emptying of the ash store, etc., the use of
personal dust protection masks and gloves is required.
For overhaul work in the storage room, low voltage bulbs must
be used. The design of electrical equipment in the storeroom
must conform to
ÖNM7137.
Page 10 of 71