Screen Layout - Herz firestar 15 Operating Instructions Manual

Screen layout

MENU NAME
D A T E STATUS TEXT
INFO TEXT
T I M E
Operating conditions (combustion control):
Unit off :
In this condition the unit is switched off.
Ready: :
The maximum boiler temperature (BOILER MAX) was switched off due too low a heat capture
being achieved and the boiler has therefore been switched off. The boiler starts up again as
long as the boiler temperature 3°C under BOILER MAX falls.
Burning phase :
In the BURNING PHASE condition, after manual start-up by the user, wait to see if the logs
catch fire in the combustion chamber. During the MAX BURNING TIME (adjustable) an
adequate flue temperature (HEATING UP FROM MIN) is adjusted so that it can be switched on
into the HIGH RUNNING PHASE condition. If this flue temperature is not set, it switches into
the UNIT OFF condition and a fault is declared accordingly.
High running phase :
In the HIGH RUNNING PHASE condition, after lightings the logs, it tries to stabilise the
combustion and achieve the minimum boiler temperature. The optional combustion control
(lambda control) is already activated at this time. When reaching 65°C the boiler temperature
(set out in the program) is switched on into the control phase. Should the flue temperature
decrease in this phase (under HEAT UP MIN), it switches into the NEW START-UP.
Control phase :
The CONTROL PHASE condition carries out actual boiler control, which splits into an output
and combustion control (OPTIONAL). If the boiler temperature in this phase increases above
the maximum boiler temperature (BOILER MAX), it switches into the READY condition.
the flue temperature decrease in this phase (HEAT UP MIN), it switches into the NEW
START-UP.
Betriebsanleitung firestar 15-40 English V2.8
Function F1
key F1
Function
F2
key F2
Function
F3
key F3
F4
Function
key F4
On
Off
E
C
On/Off
Fault
Menu
Should
Page 19 of 71