SYSTEM PARAMETERS:
AGGREGATE TEST:
OPERATING HOURS:
FAULT INDICATION:
DATE / TIME:
PRESET VALUES:
FAULT LIGHT:
When this blinks it indicates one or more faults. These are shown at the bottom right of
the display. Should several faults arise at the same time, these are displayed in the
order they arose.
In the appendix under fault reporting and repairs, you can look up what each individual
fault means. If you know which faults have arisen, then you have to repair these
mechanically first of all (in case they stem from the mechanics). After this press the F3
BUTTON (CHECK) in the service adjustments and the fault is rectified. When several
have been repaired, rectify the faults one by one.
Betriebsanleitung firestar 15-40 English V2.8
Here you can adjust the system-specific values
Here all connected components can be tested individually
Here the operating hours can be requested
Here the last 32 faults arising can be saved on 4 pages.
Here the date and clock time can be changed
Here the system can be set back to the standard values. In this
menu the lambda probe can also be calibrated.
Page 47 of 71