Table of Contents
Advertisement
Message
Rinse the fluff filter
and the plinth filter.
Check the air-
continues to
ways.
light up after a
programme has
been cancelled,
despite thorough
cleaning.
Check water drain-
age.
lights up after a
programme has
been cancelled.
Plinth filter not fitted.
Please fit it.
Fault F. If restart
fails, call Service.
lights up after a
programme has
been cancelled.
Obstruction detec-
ted. Untangle laun-
dry and restart
lights up after a
programme has
been cancelled.
Cause and remedy
The plinth filter looks clean after thorough cleaning.
However, the programme terminates and the error
message appears again. It is likely that there is still
underlying residue that could not be removed.
To delete the message: Touch the
trol.
Replace the plinth filter with a new one.
You can reactivate the removed, "old" plinth filter in
the washing machine. Follow the instructions de-
scribed in "Problem solving guide – Reactivating
the plinth filter".
The condensate drain is faulty.
Check that the drain hose is in good working order
and is not bent.
To delete the message: open and close the door
while the tumble dryer is switched on.
The plinth filter has not been inserted.
Check the filter in the plinth.
Removing the filter during a drying programme will
result in the programme being cancelled.
There is no obvious cause.
Note the prompt in the display.
Touch the
sensor control.
OK
If the programme terminates again with the same er-
ror message, then there is a fault. Contact Miele Ser-
vice.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. Take out
some of the laundry if necessary.
Close the door.
Start a programme.
Problem solving guide
OK
sensor con-
59
Advertisement
Table of Contents
