NEC N8104-149 User Manual page 28

CAUTION
Pay attention to hot surface
Immediately after the server is powered off, its internal components such as hard disk drives are very hot.
Leave the server until its internal components fully cool down before installing/removing any component.
Insert the board firmly.
Connect the board into PCI slot securely. Loose connection may cause fumes or fire.
Insert the power plug or cable into the outlet as far as it goes.
Heat generation resulting from a halfway inserted power plug (imperfect contact) may cause a fire. Heat
will also be generated if condensation is formed on dusty blades of the halfway inserted plug, increasing
the possibility of fire.
Do not hold the power plug with a wet hand.
Do not disconnect/connect the plug while your hands are wet. Failure to follow this warning may cause an
electric shock.
Do not use any unauthorized interface cable.
Use only the interface cable specified for the product. Make sure the connector type and connect with
correct destination. Improper cable connection could cause electric shock or fire due to short-circuit.
Also, observe the following precautions when handling or connecting the interface cable.
Do not use the damaged cable.
Do not step on the cable.
Do not place any object on the cable.
Do not alter, modify, or repair the cable.
Do not use the product in an environment where corrosive gas is present.
Do not install the product in a place subject to corrosive gases including sodium chloride, sulfur dioxide,
hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, or ozone. Do not install the product in an
environment that contains dust, chemicals that accelerate corrosion such as NaCl or sulfur, or conductive
materials. Failure to follow this warning may cause the wiring on the printed circuit board to short-circuit,
leading to fire. If you have any questions, contact your maintenance service company.
- 28 -