VTech DS6771-2 User Manual page 31

I cannot dial Make sure there is a dial
out. tone before dialing. It is
normal if the handset
takes a second or two
to synchronize with the
telephone base before
producing a dial tone.
Wait an extra second
before dialing.
Eliminate any
background noise.
Mute the handset
before dialing, or dial
from another room in
your home with less
background noise.
The display The handset is
shows To deregistered from the
register HS... telephone base.
and ...see
Place the handset in
manual
the telephone base
alternately. The
to register it back.
handset does
The handset shows
not work at all.
Registered and you
hear a beep when the
registration process
completes. This process
takes about 90 seconds
to complete.
The headset The headset is
deregistered from the
cannot pick
telephone base. Follow
up any call.
the steps below to
It announces
register it back.
"Not
registered".
1. Press and hold FIND
HANDSET for four
seconds. The IN USE
light turns on.
2. Place the headset on
the telephone base to
register it back.
During the registration
process, the LED light
flashes alternatively in
red and blue, and turn
red after the registration
completes. This process
takes about 60 seconds.
Lift the headset, then
press ON / OFF key
on the headset. If you
hear a dial tone, the
registration is successful.
I cannot add Make sure you have
and connect cellular coverage and the
my cell phone Bluetooth function of your
or headset to cell phone or headset is
the telephone turned on. See the user's
base. manual of your cell phone
or headset for more
information.
Make sure that the
telephone base is in
discoverable mode.
Carefully follow the pairing
instructions in this manual.
Make sure that your
Bluetooth cell phone or
headset is not connected
to any other Bluetooth
device, and is connected
to the telephone base and
active on the device list.
Turn off your cell phone or
headset, and then turn it
on again.
The cell phone If there is a location in
reception in my your house with better
house is poor reception, you can leave
and I cannot your cell phone at that
connect it to location while you use
my DS6771. the DS6771 cell line. In
order for this to work, the
telephone base must be
within 15 feet of the cell
phone.
The display Place the handset in
shows Low the telephone base or
battery.
charger for charging.
The battery Make sure the handset is
does not placed in the telephone
charge in the base or charger correctly.
handset or the
handset battery
If the battery is
does not
completely depleted,
accept charge.
charge the battery for at
least 30 minutes before
use.
You may need to
purchase a new battery.
52
The telephone Make sure the ringer
does not ring volume is not set to off.
when there is
The handset may be too
an incoming
far from the telephone
call.
base. Move it closer to
the telephone base.
My handset Move the handset closer
beeps and is to the telephone base. It
not performing may be out of range.
normally.
I hear other Disconnect the telephone
calls when base from the telephone
using the wall jack. Plug in a different
telephone. telephone. If you still hear
other calls, the problem is
probably in the wiring or
telephone service. Contact
your telephone service
provider.
I hear noise on Make sure the telephone
the cordless line cord is plugged in
handset and securely.
the keys do not
work.
There is The handset may be out
interference of range. Move it closer
during a to the telephone base.
telephone
If you subscribe to high-
conversation.
speed Internet service
My calls fade
(DSL - digital subscriber
out when
line) through your
I am using
telephone line, you must
the cordless
install a DSL filter between
handset.
the telephone line cord
and the telephone wall
jack. The filter prevents
noise and caller ID
problems caused by DSL
interference. Contact your
DSL service provider for
more information about
DSL filters.
Appliances or other
cordless telephones
plugged into the
same circuit as the
telephone base can
cause interference. Try
moving the appliance
or telephone base to
another outlet.
The location of your
telephone base can
impact the performance
of your cordless phone.
For better reception,
install the telephone base
in a centralized location
within your home or
office, away from walls
or other obstructions.
In many environments,
elevating the telephone
base improves overall
performance.
53