Snmp Configuration - Fibrenetix RS9 Series User Manual

Follow the steps below to setup an alert.
1. Select Alerts from the window on the left. Highlight the alert and select Modify.
2. Select Event Severity.
3. Enter the destination IP address to use SNMP.
4. Enter the email address you wish the send the alert to, then configure the SMTP settings
5. Enter the subject line of the alert.
6. Enter a message for the alert.
After completing the steps above, Click on <Save> to save the settings

SNMP Configuration

1. Check the box to enable the SNMP. Once it is enabled, enter information in the fields below.
2. SNMP Version: Select SNMPV2 or SNMPV3.
3. SNMPV2: If this options is selected, enter a password for ROCommunity and RWCommunity.
4. SNMPV3: If this option is selected, enter information in the fields below: Enter a username
Select the Authentication Protocol
o
Select the Private Protocol
o
Enter the Authentication Key
o
Enter the Private key
o
5. Click <Save> to save the settings.
6. Click the <Help> tab to display the Help menu. The menu includes an explanation of all the options on
this page.
28 – RS9 User Guide
Europe – Americas – Middle East | sales@fibrenetix.com | www.fibrenetix.com