Table of Contents
Advertisement
Installing and Configuring SuperDoctor5
By Default RS9 Servers are installed with superDoctor5 software, with SD5 shortcut on the desktop.
If required to Install contact Fibrenetix for the download link. Below are the installation steps.
1.
Execute the SD5 installer. Note that you must have Administrator privileges to install and run SD5.
2.
During Installation, If the Microsoft Windows SNMP service is installed, you can either:
•
install the SD5 and the SNMP extension,
3.
Select Yes to use the default key stores and click the Next button to continue
4.
Three communication modes are supported in and by default, Mode B (SSL) and Mode C (Keypair) are enabled when SD5 is
installed. You can configure the port numbers. Click next to continue.
5.
SD5 provides the Web console "SD5 Web", Select Yes to enable the SD5 Web. You can also configure the default HTTP port
number and the default HTTPS port number to access the SD5 Web. When completed, click the Next button to continue.
21 – RS9 User Guide
Europe – Americas – Middle East |
sales@fibrenetix.com
| www.fibrenetix.com
Advertisement
Table of Contents
