Pinion Error Message - Bosch ZEMO ZE FS P12 Translation Of The Original Operating Instructions

9.2.5

PINION error message

9.2.5.1 Display
The drive system monitors itself continuously and
indicates a known hazard with a warning symbol
or displays a number as an error message if a
known error is detected. The system may switch
off automatically depending on the type of error.
The pedelec can still be used as a normal bicycle
even if the motor no longer provides assistance.
Status LED
There is a status LED in the top left-hand corner
of the display screen.
Flash
Colour Status
sequence
GREE N Lights up 1
RED Lights up 1
2
RED Flashes 1
2
Table 127: Status LED
MY23Z12 - 12_1.0_26.01.2024
Connect system to
maintenance tool at the
specialist dealer's.
Restart system.
If the remote continues to light
up red, have the component
replaced at the specialist
dealer's.
Restart system.
If the remote continues to light
up red, have the component
replaced at the specialist
dealer's.
Troubleshooting, fault clearance and repair
Warnings
Hazardous situations are indicated with warning
symbols on the display screen.
Symbol Description
Temperatures are
below 4 °C
The system gives
warning of an error
Maintenance is due
Motor overheating
Reduction in power
Low tyre pressure
Table 128: List of display screen warning symbols
Method of resolution
 Take care while riding.
 Provide winter
protection.
1 Start system.
2 Contact your specialist
dealer if the problem
persists.
 Check whether buttons
are jammed because
dirt has accumulated
between them, for
example.
 Clean buttons if
necessary.
The available riding
assistance power is limited.
 Leave pedelec to cool
down.
The available riding
assistance power is limited.
 Contact your specialist
dealer.
Function is only available
with the tyre pressure
sensor.
 Check tyre pressure
and adjust if necessary.
219