Operation; Stand-Alone Mode; Interconnecting Several Devices (Master/Slave Operation); Control Board - EuroLite LED IP TL-3 User Manual

OPERATION

Connect the device via the mains cable to a grounded mains socket. Thus the device is switched on and
starts running.
The display lights up and you can choose the desired mode via the buttons MENU, ENTER, UP, DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board and the
EUROLITE IR-38 remote control or in DMX-controlled mode via a standard DMX controller.

Stand-alone mode

In the stand-alone mode, you can do without a controller. Disconnect the device from the controller and call
the desired setting. Please refer to the instructions under Control Board.

Interconnecting several devices (master/slave operation)

Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1. Configure all slave units before connecting the master unit: Press the MENU button so many times until
"MASTSLAV" is indicated on the display. Confirm with the ENTER button. Set "Slave" on all slave units
with the UP and DOWN buttons. Confirm with the ENTER button. Set "Master" on the master unit using
the UP and DOWN buttons. Confirm with the ENTER button.
2. Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3. Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.

Control Board

The Control Board offers several features: you can easily set the starting address, run the pre-programmed
program or select a DMX channel mode.
The main menu is accessed by pressing Menu. Browse through the menu by pressing Up or Down. Press
Enter in order to select the desired menu. You can change the selection by pressing Up or Down. Press
Enter in order to confirm. You can leave every mode by pressing Menu. The functions provided are listed in
the following sections.
If you press and hold Up or Down, the values change faster. The device has an automatic storage for all
settings. When you switch the device off and on again, it will operate with the previously set values.
Default settings in bold
MAIN level Menu level
DMX Addr 001-512
3CH, 4CH, 6CH,
DMX Chan
8CH, 11CH
OFF/Dim1/Dim2/
Dimmer
Dim3/Dim4
Mast/Slav Master/Slave
Description
DMX address setting
Setting DMX channel mode
Dimmer speed (step response)
OFF: Response characteristics of LEDs
Dim1: Response characteristics of halogen lamps, fast
Dim2: Response characteristics of halogen lamps, less fast
Dim3: Response characteristics of halogen lamps, middle
Dim4: Response characteristics of halogen lamps, slow
Master/Slave mode
(Master =control without external controller)
(Slave= control with external controller)
27/36 00151247, Version 1.0