Operation; Menu Structure; Stand-Alone Mode - EuroLite LED Theatre COB 100 UV User Manual

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board or in DMX-controlled mode via any commercial DMX controller.

Menu structure

Mode
DMX mode
Automatic mode
Sound control
Running speed in
automatic mode and
sound control
Microphone sensitivity
for sound control
UV color setting
Dimmer
Sound control silent
scene
Behaviour in case of
missing DMX signal
Slave mode
Firmware version

Stand-alone mode

Automatic mode
In automatic mode, 5 show programs are available that run at an adjustable speed.
1 Press the MENU button so many times until Auto is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program (Au 1 – 5). Confirm with the
ENTER button.
2 Press the MENU button so many times until SPEE is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from SP 1 (slow) to
SP 9 (fast). Confirm with the ENTER button.
Display
4CH
Addr
1CH
Auto Au 1 – 5
Soun So 1 – 4
SPEE SP 1-9
SEnS SE 1-9
Colo u000-255
diMM dI 1-dI 9
on
SILE
oFF
bLac
HoLd
LoSt
FuLL
Auto
SLAV Slave
Vx.x Vx.x
22/28
d001-509 4-channel mode and start address
d001-511 1-channel mode and start address
Program 1 – 5
Program 1 – 4
Program running speed
slow > fast
Microphone sensitivity
low > high
UV 0-100%
Total brightness (Auto, Soun, and
Colo modes) dark > bright
LEDs off if there is no music signal
LEDs remain on if there is no music signal
LEDs go off
Spot holds the last received signal
LED 100% on
Pre-selected auto program 01-05
Slave mode
Firmware version number
Function
00137882, Version 1.0