Connection To The Mains; Operation; Menu Structure - EuroLite LED DMF-4 User Manual

Connection to the mains

The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1 Connect the device via the mains cable to a grounded mains socket. Thus the unit is switched on.
2 To switch off the unit, disconnect the power plug.
3 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board and the EUROLITE IR-7 remote control or in DMX-controlled mode via any
commercial DMX controller.

Menu structure

Mode
DMX channel
Preset colors
Automatic mode
Sound control
Running speed in
automatic mode and
sound control
Microphone sensitivity
for sound control
Sound control silent
scene
Behaviour in case of
missing DMX signal
Slave mode
IR remote control
Firmware version
Display
Addr 7CH
Stat S 01-08
Auto Au 1 – Au 4
Soun So 1 – So 4
SPEE SP 1-9
SEnS SE 1-9
on
SILE
oFF
bLac
HoLd
LoSt
FuLL
Stat
Auto
SLAU Slave
on
InFr
oFF
V1.0 V1.0
22/28
Function
d 1-512
Constant lighting in one of 08 colors or
color combinations,
only for flower effect
Auto Program
Sound Program
Program running speed
slow > fast
Microphone sensitivity
low > high
LEDs off if there is no music signal
LEDs remain on if there is no music
signal
LEDs go off
Spot holds the last received signal
All LEDs 100% on
Pre-selected static color 01-08
Pre-selected auto program 01-04
Slave mode
IR remote control on
IR remote control off
Firmware version number
00134126, Version 1.0