Installing The Hard Drive; Bezel; Removing Front Bezel - Dell OptiPlex 3070 Small Form Factor Service Manual

Installing the hard drive

NOTE: For configurations shipped with 3.5-inch HDD, follow the same procedure to install the HDD into its bracket.
1. Insert the holes on one side of the hard disk into the pins on the hard drive bracket [1], and then place the hard drive into the bracket
such that the pins on other side of the bracket is aligned with the holes on the hard drive [2].
NOTE: Follow the same procedure to install another 2.5-inch hard drive on the other side of the bracket.
2. Install the:
a) HDD assembly
b) side cover
3. Follow the procedure in

Bezel

Removing front bezel

1. Follow the procedure in
2. Remove the Side cover.
3. To remove the front bezel:
a) Pry the retention tabs to release the front bezel from the system [1].
b) Rotate the front bezel away from the computer [2] and pull to release the hooks on the front bezel from the front-panel slots [3].
After Working Inside Your Computer.
Before working inside your computer.
Removing and installing components 73