Philips Aqua Plus XC8347/01 Manual page 13

Problem
Dust escapes from the
appliance.
This icon flashes on the
display:
The appliance does not
move smoothly across the
floor when I am cleaning a
carpet.
The brush does not turn
anymore.
The LEDs in the nozzle do
not come on.
The appliance is not
charging.
Possible cause
The filter is dirty.
The filter is not present in the
appliance.
Something is blocking the
cyclone.
If dust falls out of the dust
container, the dust container
lid is probably not attached
properly to the dust
container.
The filter may be dirty.
You selected a too high
suction power.
The brush is clogged with
hair or dirt.
The brush may stop turning
when it encounters too much
resistance from high-pile
carpet.
You have not assembled the
roller brush into the nozzle
properly after cleaning.
You have not attached the
nozzle to the tube or
appliance properly.
The magnetic connector is
not connected properly to
the charging disk or the
adapter is not inserted into
the wall socket properly.
You have not connected the
adapter supplied.
Solution
Clean the filter (Fig. 10). See also the user
manual.
Make sure that the filter is in the
appliance and assembled correctly.
Check the cyclone (Fig. 12) for objects
stuck in it and remove any object that is
blocking the cyclone. Make sure that you
remove any hair and dirt that is stuck in
the cyclone.
Empty the dust container and attach the
dust container lid correctly.
We advise you to clean the filter (Fig. 10).
If you cleaned the filter recently, you can
disregard this icon. To continue
vacuuming, switch the appliance off and
then on again.
Reduce the suction power by choosing
setting 1.
Clean the brush with a pair of scissors or
by hand.
Switch off the appliance and then switch
it back on again.
Follow the instructions in the cleaning
chapter to slide the roller brush into the
nozzle properly. Secure the roller brush
inside the nozzle by snapping the
locking lever in place.
Attach the nozzle to the appliance or
handheld properly.
Make sure that the magnetic connector
is connected properly to the charging
disk and that the adapter is inserted into
the wall socket properly.
Make sure that you use the adapter
supplied.
English
15