Advertisement
Available languages
Available languages
28
www.raider.bg
6.9. Charging rechargeable batteries at temperatures below 10 % will cause chemical damage to the cell and may
cause a fire.
6.10. Do not use batteries that are heated during the charging process, as the battery cells may have malfunc- tioned.
6.11. Do not use batteries that have been bent or deformed during the gas charging / discharging process, cracking,
whistling, etc.).
6.12. Never discharge the battery / recommended discharge level max. 40%). Full discharge of the battery will cause
premature aging of the battery cells.
6.13. Never charge and leave the battery unattended.
6.14. The present charger is not intended for use by persons (including children) with limited physical, sensory or
mental capabilities, or for persons without experience and knowledge of the equipment unless the use is monitored or
in accordance with the instruction manual for the device transmitted by persons responsible for safety. Care must be
taken to ensure that children do not play with equipment.
6.15. The charger must not be exposed to moisture or water. The entry of water into the charger increases the risk of
electric shock. The charger can only be used indoors in dry rooms.
6.16. Before carrying out any maintenance or cleaning of the charger, you must disconnect the charger from the power
supply.
6.17. Do not use the charger on a flammable substrate (eg paper, cloth) or near flammable substances. Due to the
charging of the charger in the charging process, there is a risk of fire.
6.18. Check the status of the charger, cable, and plug before each use. In the event of faults, do not use the charger.
Do not attempt to disassemble the charger. All repairs should be assigned to an authorized repairer. Incorrect
installation of the charger may result in electric shock or fire.
6.19. When the charger is not in use, it must be disconnected from the mains.
6.20. It is forbidden to repair a damaged charger. Carrying out the repair of the charger is only permitted by the
manufacturer or an authorized service center.
7. Protection against environmental impact.
7.1. Protect the charger and the batteries from moisture and rain. Moisture and rain can cause dangerous damage.
7.2. Do not use a charger or battery near flammable vapors and liquids.
7.3. Use the charger and the battery only in dry places and at an ambient temperature of 0-45 ֯ C.
7.4. Do not store the charger and battery in places where the temperature may reach over 30 ° C. In particular, do not
leave the charger in a car parked in the sun.
7.5. Protect the batteries from overheating. Overloading, overcharging, and exposure to direct sunlight will result in
overheating of the cells. Never charge or operate batteries that have overheated - replace them as soon as possible.
7.6. Storage of batteries, chargers and rechargeable tools. Conditions for use.
Store the charger and the battery charger only in a dry place and at an ambient temperature of 10-30 ° C. Protect
them from moisture and direct sunlight. Only recharge fully charged rechargeable batteries / charged at least 40% /.
When operating, use the battery charger, angle grinder and battery only in a dry place and at an ambient temperature
of 0-45 ֯ C.
7.7. Protect the lithium-ion battery from frost. Rechargeable batteries that are stored below 0 ֯ C for more than 60
minutes should be discarded.
19.8. When handling batteries, be aware of the electrostatic charge. Electrostatic discharges cause damage to the
electronic protection system and battery cells. Beware of the electrostatic charge and never touch the battery poles.
8. Maintenance and service.
8.1. Maintenance and cleaning.
To work well and safely, keep the angle grinder and the ventilation openings clean. Make periodic breaks in work. Store
and handle the accessories carefully.
Wipe the machine with a clean cloth or blow it with compressed low pressure air. Clean it regularly with a damp cloth
and a little soft detergent. Do not use detergents or solvents.
8.2. The cordless brush cutter is equipped with a brushless motor.
8.3. If an abnormal noise occurs on the cordless brush cutter, stop working immediately and contact your nearest
RAIDER service center.
9. Environmental protection.
9.1.In order to protect the environment, the power tool and packaging must be suitably processed for the re-use of
the raw materials contained therein. Do not dispose of power tools in household waste! According to the European
Union Directive 2012/19 / EC on end-of-life electrical and electronic devices and the validation and as a national law,
Advertisement
