Sony CBK-RPU7 Operating Instructions Manual page 25

Item
SDI Input
Test Signal
Video
Moving
Audio Test Tone
Note
During streaming, settings other than [Test Signal] cannot be changed.
WAN List tab
This tab is used to create a list of destinations to which the unit will transmit. The settings of receivers are
required to create a list for transmission. Check the settings of devices beforehand. The destinations that
you create are used when selecting a [Destination] on the [Settings] tab.
Description
Selects the type of the input connectors for 4K input over SDI.
• 12G
• 3G ×4
Note
This item is displayed only when a resolution of [3840×2160p] (except when [System
Frequency] is set to 23.98 Hz) is selected. When [System Frequency] is set to 23.98 Hz,
SDI (Quad Link) input is not supported.
Selects whether to transmit the internal test signal instead of the input signal.
• OFF
• ON
Selects whether to output the test signal internal video as still image color bars or
moving color bars.
• OFF
• ON
Selects the level of the test signal internal audio (1 kHz tone signal).
• Mute
• –24dB
• –22dB
• –20dB
• –18dB
• –16dB
• 0dB
25