Troubleshooting
10
Troubleshooting
This chapter should enable the maintenance personnel to identify and resolve operational faults based on error
messages and symptoms.
Warning
Risk of fire from incorrect parameter settings.
Laser operation with incorrect parameter settings such as power settings, speed or frequency can result in
flame formation.
–
Laser operation permitted only under supervision.
Caution
System failures that cannot be remedied can cause damage to the machine.
–
Disconnect the machine from the mains and contact your local Technical Support.
10.1
Error, cause and remedy
Problem
Too low engraving depth.
Blurred edges.
Missing cut lines.
Waviness of the lines.
No visible marking result.
Fine details on stamps are
engraved too thinly.
78
Possible cause
Imprecise focusing.
•
Dirty optics.
•
Imprecise focusing.
•
Zero passes in material database.
•
Line thickness in CorelDraw too
•
big.
Color was skipped in the
•
soware.
Lens is loose.
•
Too low laser power.
•
Too high speed.
•
Not focused.
•
Wrong focus tool.
•
Too steep shoulders.
•
Remedy
Check focus.
•
Clean optics.
•
Check focus.
•
Increase the amount of passes in
•
the material database.
Reduce line thickness to the
•
smallest possible value.
Set color to cutting in the
•
database.
Check lens and lens holder.
•
Increase power setting.
•
Reduce speed.
•
Check focus.
•
Change focus tool.
•
When using autofocus, check the
•
settings within the soware (lens,
material thickness, table).
Choose other shoulder or edit
•
(flat/medium/steep): Options/
Process Options/Stamp.