Table of Contents
Advertisement
Troubleshooting
These errors are encountered when conducto probe cable harness occurs or cable sockets installed in wrong direction.
Machines with pressure switch feature, in washing cycle, after water inlet is completed the pressure switch is clicked. If it is not, pres-
sure switch fault is encountered.
At the water inlet part of the program, after enough amount of water is taken into the sump (approx .66 Gallons); pressure switch is
expected to be closed.
Page 36 of 41
Conducto Probe/Short Circuit Faults E:11 / E:12
Possible reasons:
•
Cable harness errors
•
Faulty socket installation
Pressure Switch Fault E:13
Possible reasons:
•
Faulty pressure switch
•
Faulty water inlet counter
•
Faulty electronics
December 12, 2018
Advertisement
Table of Contents
