Table of Contents
Advertisement
Service Procedures
If not initiating the automated service test, the next service menu item is Shown above
when stepping to the next menu item. This is the "EEP" (Eprom reset function), which will
restore all factory settings to all parameters.
Press the Start/Pause pad to reset the Eprom, see below illustration.
With "rSt" flashing in the display as shown below, the Eprom has been reset to factory settings. Press-
ing the On/Off pad will save the new settings and turn off the machine.
Press the time delay + tab again to go to the next item in the settings menu, software display
, see below.
Page 28 of 41
December 12, 2018
Advertisement
Table of Contents
