Table of Contents
Advertisement
Pager Call
o
&®
eh
LE
a RES
Se
EP
eae A
dF
Se
Pa oh |
Re
mn
a aa a naa
a n
This feature allows you to alert your pager when the unit records an
incoming message or receives a Caller ID call (p. 58). You can retrieve
the message from a touch tone telephone (p. 60). If you subscribe to a
Caller ID service, the caller's telephone number will be displayed on your
pager. First program the following settings (p. 55-58), then set the unit to
call the pager. The TALK indicator light must be off and the base unit
must be in the stand-by mode before programming.
Storing a Pager Number
If you use a 1-800 pager number, see the next page for the storing
procedure.
1
Press
(PROGRAM).
l
oThe TALK indicator flashes.
oThe IN USE/CHARGE indicator lights.
Press
(PLAYBACK).
e"P" is displayed on the base unit.
2
3 Press (#).
4
TALK Indicator
o"—" is displayed on the base unit.
Enter your pager number, and —
>
press
twice.*
3
Enter the access code, if required
=
by your pager company, and press
2
twice again.*
a
©The entered number is displayed on
the base unit.
olf you misdial, press (PROGRAM)
—
and start again from step 1.
oYou can enter a total of 44 digits.
5
Press
(PROGRAM).
oA beep sounds.
Pager companies require a delay after the pager number and/or the
access code is dialed. Contact your pager company regarding the
required pause time. Pressing
(REDIAL/PAUSE } once creates a
3.5 second delay and counts as one digit.
olf the line has rotary or pulse service, press [TONE ) between the pager number
and |[REDIAL/PAUSE)
in step 4.
55
Advertisement
Table of Contents
