Fisher & Paykel DISHDRAWER DD24STI Installation Manual page 13

!3 A
- PULL THROUGH HOSES & MOVE INTO THE CAVITY
Vent hose either
through same cabinet
or adjacent cabinet as
per Step 7b or 7c
!5 A
- SECURE THE EXTERNAL VENT
1
After routing the vent hose through
and out the hole cutout, attach and
secure the vent by tightening the
four screws provided.
As you push product in, pull through hoses and
cord, ensuring they don't get kinked or twisted.
IMPORTANT!
If product cannot be pushed in far enough,
pull out again and rearrange hoses and cord.
Do not use excessive force, as doing so
may squash the hoses and lead to incorrect
operation.
2
!4 A
- SECURE TO THE CABINETRY ON THE SIDES
Open the
drawer halfway.
Using a flat
bladed
screwdriver,
prise the gray
rubber plug out
of the trim
moulding.
2
Using a small
Philips screwdriver,
screw through the
trim moulding,
securing the side
mounting bracket
to the cabinetry.
Do not damage
the rubber
trimseal.
1
Replace the gray
rubber plug back into
the trim moulding
and ensure the trim
seal is facing forward.
3
Repeat for all
four brackets.
12