FRONT PANEL MATERIAL SPECIFICATIONS
5/8 - 13/16" (16 - 20mm) panel thickness
●
Adequately sealed to withstand moisture (122
●
Because of it being a hot and wet environment generally, the back and sides of the
panel should be completely sealed with a waterproof vapour barrier (ie polyurethane)
to prevent damage to the panel.
The back of the panel (including any integrated handle) should be completely flush so
●
that the seal between the panel and the rubber trim is maintained.
Installation outside these specs may result in condensation on cabinetry surfaces.
●
Maximum weight of panel: 20lb (9kg)
●
The following calculations assume the top of the upper panel is
aligned with the top of the adjacent cabinetry.
WIDTH OF THE PANEL
Measure A (the width between adjacent door/drawer fronts)
and write it in the first box below, then complete the equation.
Clearance to adjacent
cabinet front
A
- 2x
(min. 1/16" (2mm))
HEIGHT OF THE PANEL
Ventilation Gap
B
-
(min. 1/16" (2mm))
7
6
CUSTOM DRAWER PANEL SPECIFICATIONS
O
F/50
O
C @ 80% RH)
WIDTH OF PANEL
=
(23 7/16"-24 3/16" (596-615mm))
HEIGHT OF PANEL
=
Note: when the top of the dishwasher
has to be lower than the adjacent
cabinetry, the top of the panel can
extend above the chassis where required,
however a min. 1/16" (2mm) gap to
the benchtop must be maintained.
min. 1/16" (2mm)
min. 1/16" (2mm)
B
PANEL
WIDTH OF PANEL
Ventilation Gap (min. 1/16" (2mm))
with External Venting Kit installed
1/16" (2mm)
A
min. 1/16" (2mm)
HEIGHT OF
PANEL
Ventilation Gap
min. 1/16" (2mm)
with External Venting
Kit installed