Table of Contents
Advertisement
To listen to the desired audio sound, set
the AUDIO setting of the VCR mode MENU
(see page 17) as follows
AUDIO The following selections are
available for 12 bit AUDIO dubbed
recordings only (sound recorded in SP
mode only)
ST 1
Set this position to listen to the
original sound
ST 2
Set this position to listen to the
audio dubbed sound
MIX
Set this position to listen to both
the original sound and the audio
dubbed sound
Note
• 16 bit dubbed sound completely erases
the original 16 bit recorded sound
• If you dubbed using 12 bit AUDIO
recording and then selected AUDIO-MIX
in the menu for playback, the sound will
be stereo regardless of the AUDIO-OUT
setting
• If you recorded in LP mode, you cannot
use the A DUB feature
Press 11 (PAUSE) to start Audio
Dubbing
• Connect the Palmcorder to the TV in
order to monitor the sound
(See page 31 )
-\
1NCOMPAT1BLE
TAPE
J
Only NTSC (National Television Standards
Committee) recorded tapes can be audio
dubbed The following screen appears if
the tape was not recorded in NTSC format
5 Press M (PAUSE) to stop Audio
Dubbing
• If the microphone used for dubbing gets
too near the speaker of your TV,
a howling noise (feedback) may occur
• If the tape position is in or was started in
a blank section, you cannot use the
A DUB feature
?Memory-Stop Editing (Remote 1
jjiCqfltrol Onjy)
You can set an automatic Dubbing stop
point
PV-DV701 Supplied
PV-DV351 Optional
Dreset
Button
Amenu
Button
CD CD | CD (Q)
fc5 c5 |=j
*• **■ _ —hF
ksnziE)
<3 di
A
B
Press MENU to display the VCR
menu screen
DISRIFAM
Rotate JOG KEY to select]
HstmiflHc)]. and then press JOG KEY
to display the DISPLAY SETTING
menu
Rotate JOG KEY to select DISMAY
and then press JOG KEY to set to
MEMORY
1^) Press MENU two times to exit MENU
mode Then, press RESET on the
remote control to reset the Counter
Memory to M 0 00 00
Now, rewind to the editing start point,
and continue with steps 2-5 The tape will
now stop automatically at "M 0 00 00"
51
Advertisement
Table of Contents
