Panasonic Digital Palmcorder PV-DV351 Operating Instructions Manual page 26

"Remote ControllingfTwo *
Palmcorders ;t
You can control any two Panasonic
Palmcorders with one Remote control. In
order for the remote to distinguish between
the two units, it is necessary to set one of
the Palmcorders to VCR 2. On the remote,
press VCR 1 or VCR 2 to control the
desired Palmcorder.
PV-DV701 Supplied
PV-DV351 :Optlona1
For VCR 2 :
Press these
buttons at the
same time.
For VCR 1 :
Press these
buttons at the
same time.
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE
(REMOTE)" will appear.
'
—\
remote
_/
1 Set POWER to VCR or CAMERA.
2
3
4
5
• The POWER Lamp lights red.
• Be sure POWER is fully turned to
VCR or CAMERA position.
Press MENU to display the VCR or
CAMERA mode menu screen.
Rotate JOG KEY to selectgjggjlyin
the CAMERA mode menu screen or
IQin the VCR mode menu
screen, then press JOG KEY to
display the CAMERA SET-UP or VCR
PLAY MODE menu screen.
REMOJE
Rotate JOG KEY to select |_
and then press JOG KEY to select
VCR 2. (See pages 16, 17). Leave the
other Palmcorder set to VCR1.
Set the Remote Control to VCR 1 or
VCR 2 to correspond with the
Palmcorder you wish to control. (See
above left.)
• After replacing the Remote Control
Battery, the remote will default to VCR 1.
Replace the Battery
PV-DV701: Supplied
PV-DV351 :Optional
O
•$3
1 While pressing the tab in the direction of the arrow (A) with
your fingernail, pull out the Battery Tray (B).
2
Insert the battery into the Battery Tray with the @ mark
facing up.
Do not reverse the polarity.
3
Insert the Battery Tray.
rReplace battery with Panasonic PART NO. VSBW0004 (CR2025) 1 2 3
only. Use of another battery may present a risk of fire or explosion.
Caution: battery may explode if mistreated. Dispose of used battery
properly. Keep away from children. Do not recharge, disassemble or
^dispose of in a fire.
26
For assistance, please call: 1-800-211-P AN A(7262) or
sende-maifto: consumerproducts@panasonic.com