Related Manuals for FLUX POWER M36-G1
Summary of Contents for FLUX POWER M36-G1
- Page 1 Installation Flux Power M36-G1 Installation Guide WARNING – Risk of Fire – No User Serviceable Parts...
- Page 2 Installation 1 Deliverables Battery Weight Adapter QTY: 1 Qty: 1 Power Cables Pre-inserted into Battery (varying connector External SOC Gauge and length) QTY: 1 QTY: 1 External Harness (varying connections and length) Telematics Box (if applicable) QTY: 1 QTY: 1...
-
Page 3: Battery Installation
Installation 2 Battery Installation 2.1 Installing Battery into Weight Adapter 2.1.1 Lifting Points Use the two lifting rings of the battery to lift the battery. A set of hooks with proper chains or lifting straps is recommended. - Page 4 Installation 2.1.2 Orientation The battery should be oriented such that the front of the battery faces the same direction as the open side of the weight adapter. The I.D. plate of the battery faces this direction as well.
- Page 5 Installation 2.2 Installing Battery and Weight Adapter into Truck 2.2.1 Lifting Points Use the two lifting points on the side of the weight adapter to lift the unit. A set of hooks with proper chains or lifting straps is recommended.
- Page 6 Installation 2.2.2 Slide-in Sliding the battery into the compartment requires the battery and weight adapter to be suspended in the air and then pushed into the compartment. The truck's battery compartment will have a sliding tray for the battery to slide in and out of the compartment.
- Page 7 3.1.2 Mounting Location Mount the external SOC gauge so that the Flux Power logo and the LEDs face the operator. Mount the SOC gauge on a secured spot where collisions with other objects cannot damage it.
- Page 8 Installation 3.2 Telematics 3.2.1 Mounting Points Use the four holes on the side to mount the telematics box onto the truck by tapping into the truck frame, or use the two slots on the side to zip-tie the telematics box onto the truck frame. 3.2.2 Mounting Location Mount the telematics box underneath the overhead guard.
- Page 9 Installation 3.3.2 Mounting Location Wrap the external harness inside the truck frame to limit damage to the harness from the truck's surroundings. Recommended locations are highlighted in striped green. Areas to avoid are highlighted in checkered red. Recommended locations in striped green:...
- Page 10 Installation Avoid mounting the harness in areas where it can be pinched or scraped. Areas to avoid in checkered red...
-
Page 11: Operation
Installation 4 Operation 4.1 Discharging the Battery The battery must have an external harness and all connectors connected adequately to any external accessories present to discharge. External harness connections will vary between different harnesses and truck configurations. An external harness will connect to the battery's 12-pin communications port. The battery's power cables will have a complimentary connector to the truck. - Page 12 Installation Telematics harness connection is a 4-pin connection: The external SOC gauge connection is a 9-pin connection. Turn the set screws on the connector to properly secure this connection:...
- Page 13 Installation The battery is turned ON by pressing the push button so that it is indented inwards. When the battery is ON, the push button will illuminate. The battery is turned OFF by pressing the same button so that it indents out. When the battery is OFF, the push button will no longer illuminate.
- Page 14 Flux Power, Inc. All other brands and product names are trademarks or registered trademarks of their respective owners. This information is intended for the use of Flux Power customers only. Any other use without the express written consent of Flux Power, Inc. is strictly prohibited...