Related Manuals for FLUX POWER S Series
Summary of Contents for FLUX POWER S Series
- Page 1 User Guide Flux Power LiFT Pack S-Series S8 BMS2 User Guide WARNING – Risk of Fire – No User Serviceable Parts...
- Page 2 User Guide Safety Precautions The Flux Power Lithium-ion battery is composed of lithium-ion cells and is classified as Class 9 miscellaneous hazardous material. Precautions to correctly handle the Flux Power lithium-ion battery include: The battery shall only be handled by Flux Power authorized personnel familiar with handling, storing, and the •...
-
Page 3: Table Of Contents
Flux Power Lithium-ion battery Basics ....................4 Construction ...........................4 Initial Startup ..........................4 Charger ............................5 2.3.1 Opportunity Charging ........................5 Flux Power Battery Management System (BMS) ................6 2.4.1 Cell Balancing ..........................6 State of Charge (SOC) Gauge ......................6 Temperature ..........................6 Optional Heaters ..........................6 Storage ............................7 Auto-Sleep Mode ...........................7... -
Page 4: Introduction
Initial Startup Flux Power LiFT Pack batteries are shipped in storage mode. To activate the battery, fold in the yellow tab on the breaker located in the cable storage box as shown in figure 2. The state of charge (SOC) gauge will illuminate and the... -
Page 5: Charger
Charger Use only a Flux Power approved charger for external charging of the 100 and 180 Amp Hour batteries. External charging is only approved for packs with serial number 180500 and above. External charging is not approved for the 72 Amp Hour pack. -
Page 6: Flux Power Battery Management System (Bms)
Figure 3: SOC diagram Temperature Flux Power LiFT Pack batteries without the heater option have an operational ambient temperature range of 0°C / 32°F to 55°C / 131°F. The BMS will prevent operation outside these temperatures. Battery packs subjected to low temperatures 0°C / 32°F (or lower) may experience decreased performance if not equipped with the heater option. -
Page 7: Storage
User Guide If the battery is left unattended in sub-zero temperatures, the heaters can discharge the battery within 48 hours. The BMS will protect the battery from over-discharge by turning off the heaters at 20% SOC and will remain off until the battery is plugged in for charging. -
Page 8: State Of Charge (Soc) Gauge And Device Trouble Codes (Dtcs)
A single LED blinking indicates a Device Trouble Code (DTC). DTCs let the user or technician quickly assess why a battery may be disrupting operation. The following list details each DTC. Situations where the Flux Power lithium battery will cut power and display a DTC Fault... -
Page 9: Safety And Reliability
Flux Power LiFT Packs are completely sealed and require no watering. No electrolyte must be added and there is no danger of acid spills or explosive vapors during normal use. In addition, the Flux Power LiFT Pack S8 is designed to pass the UL 2580 standard. -
Page 10: Heavy Water Spray
Contact Flux Power if you need assistance. If you are unable to locate a lithium-ion recycler in your area, Flux Power agrees to take back any battery that is at its end of life. -
Page 11: Shipping Information
Flux Power, Inc. All other brands and product names are trademarks or registered trademarks of their respective owners. This information is intended for the use of Flux Power customers only. Any other use without the express written consent of Flux Power, Inc. is strictly prohibited...