Start And Stop; Control Before Starting - Husqvarna 326P4 Series Operator's Manual

START AND STOP
Control before starting
• Inspect the working area. Remove ob}ects thai: can be
lhrown,
, , [][]
• Check the cutting-
equipment. Never use
blunt, ca'ackedor
damaged eqkiipment,
• Check that the machine
ksin full working ordea
Check lhat all nuts and
bolts are tighlvned
cow, oily,
• Make skirethe chain ksalways well lubricated,
• Enskirethe ckittingeqkiipment alwa_ slop when lhe engine
ks idling,
• Only kise the machine for what tt is inlended for,
• Enskir<_ t ha the handle and sa_'elyfuncllons are in ordea
Never use a machine that Iacks a part or has been modified
ore:side of the specifications.
Start and stop
Cold engine
_GNI FION:
Set the stop switch to the
slza't postlton,
CHOKE:
Set the choke control in the
choke position.
AIR PURGE:
Press the air pkirge
diaphragm repealedly kimtI
fuel begil_s lo fiI] lhe
diaptu'agm. The diaph*'agm
need not be completely
filled,
Warm engine
Use the s_e st_tt_
procedure as
for the coId
engine, bait do not set the
choke control in the choke
position, The sta*_ throttle position ks obtained by setting the
choke control in the choke position and then returning it to its
original position,
Stop
The engine is stopped by
switching off the ignition,
Start
Press the machine body
agaiust the ground using
you*' left:hand (NOTE{ Not
your too 0- Grip the siarler
handle, slowly pull out lhe
coM with yokir
right
hand
k!n{i] yOki feel soIlle
resistance
(the sh_rler pawls grip) now
quickly and powerfully pull
the cord.
Reset the choke control as
soon as the engine fi*_sand
repeat until the engine stalls,
Vqhen the engine starts
quickly apply full throttle
and the sL_rtthrottle will
am:omagcally dksengage,
NO I'E! Do not pkill the
starter cord out completely
and do not rele_se lhe sla_ter
cord Dora the fully extended
posttton, Thks can damage
the *llachtrle, Also lake
Care
to eusure that the rattling
athqehment is not louehing
the ground when yoki slart
the *llaehine.
O
_0- EagIk_h