Lincoln Electric IDEALARC SP-255 Service Manual page 38

C-3
STITCH KEY
Anytime the Stitch weld timers are on and the display is
in Spool Mode, the abbreviation STCH will appear in the
bottom left corner of the display.
SPOT STITCH: ON - - - OFF
SET
DISPLAY
Stitch On Time
TYPICAL STITCH KEY PRESS SEQUENCE
Spool screen is displayed prior to pressing Stitch key.
Stitch timers are activated and the display changes to
Stitch screen. Stitch ON and OFF timers can now be
adjusted using the center and right arrow keys. Once
the timers have been set, pressing the Stitch key again
returns the display to the original Spool screen with the
Stitch timer status indicated in the bottom left corner.
Press
SPOOL: WFS VOLTS STITCH
18.0
50% SET
DISPLAY
Press
STITCH
SET
DISPLAY
TOGGLE KEY
Memory Currently Active
TOGGLE 4 SPOL: WFS VOLTS
SPOT 50% 18.0
4 5
The first time this key is pressed it turns on toggle mode
and recalls the setup in memory 4. This mode allows
you to toggle between the setups in memory 4 and
memory 5. Each time the key is pressed, it alternates
between the two memories. The toggle screen displays
the memory number the current setup was recalled
from, indicates spool (SPOL:) mode, displays percent-
age of wire feed speed, and set arc voltage. The cursor
underlines the memory number currently selected.
ACCESSORIES
1.25s
1.90s
Stitch Off Time
Set Timers
STITCH: ON - - - OFF
1.25s
1.90s
SPOOL: WFS VOLTS
STCH 50% 18.0
5 SPOL: WFS VOLTS
STCH 50% 18.0
IDEALARC
TYPICAL TOGGLE KEY PRESS SEQUENCE
Spool screen is displayed prior to pressing Toggle key.
Toggle key is pressed, memory 4 is recalled and ap-
pears on the display. The unit is now in toggle mode.
Pressing the Toggle key again "toggles" the unit, and
memory 4 is recalled and appears on the display. This
whole cycle is repeatable as long as the unit remains in
Toggle mode.
SPOOL: WFS VOLTS TOGGLE
50% 18.0
4
4 SPOL: WFS VOLTS
SPOT 18.0
50%
DISABLING SPOOL GUN
When the Spool Gun Adapter box transfer switch is set
to FEEDER Gun position, the display will flash between
these two messages:
SPOOL GUN HAS
BEEN REMOVED
Pressing the Process key will return you to the last
process entered before the Spool gun was attached.
ENTER SOLID STEEL
PROCESS
WIRE .035
WIRE/GAS
SP-255
®
C-3
Press
5
Press
5 SPOL: WFS VOLTS
TOGGLE
18.0
STCH 50%
4 5
Press
TOGGLE
4 5
PRESS PROCESS TO
ENTER SETTINGS
GAS
ArCO
2