Table of Contents
Advertisement
94 Installation example of drive module with IP20 shrouds (option +B051)
Step
3
Step drill carefully sufficiently big holes to the lead-through clear plastic shroud for the cables to the
connected. Align the holes in the vertical direction according to the alignment holes in the shroud.
Smooth the hole edges.
Remove the plastic sheeting from both sides of the shroud.
Attach the cables firmly to the cabinet frame to prevent chafing against the hole edges.
4
Put the conductors of the input cables through the drilled holes in the clear plastic shroud.
5
For drive modules without option +H370: Connect the input cable conductors to the drive module
L1/U1, L2/V1 and L3/W1 connection busbars, Go to step 12.
For option +H370: Do steps 6 to 11.
6
Screw in and tighten the insulators to the drive module by hand. Install the L1/U1 connection
terminal to the insulators.
WARNING! Do not use longer screws or bigger tightening torque than given in the
installation drawing. They can damage the insulator and cause dangerous voltage to
be present at the module frame.
7
Connect the L1/U1 conductors to the L1/U1 connection terminal.
8
Install the L2/V1 connection terminal to the insulators. See the warning in step 5.
9
Connect the L2/V1 conductors to the L2/V1 connection terminal.
10
Install the L3/W1 connection terminal to the insulators. See the warning in step 5.
11
Connect the L3/W1 conductors to the L3/W1 connection terminal.
12
Install the lead-through clear plastic shroud. Install the front clear plastic shroud and upper front
cover. Remove the cardboard protective covering from the drive module air outlet.
13
Install the side and top clear plastic shrouds to the drive module.
Task (input cables)
Advertisement
Table of Contents
